Penny Board 1.0

by fntsmn

THIS MODEL IS COVERED BY MMF COPYRIGHT, SO YOU CANNOT SELL IT OR UPLOAD IN OTHER WEBSITE WITHOUT MY PERMISSION I look around and i find someone try to replicate the Penny Board but without success, so i decide to take this challenge and i won! I suggest to print the pin in 100% and all the other piece with an infill from 25% to 100%. The back part i suggest to print from 75% to 100% need to be really strong! You need 3 steel bar with 6.4mm diameter: - 2 long 43 cm - 1 long 45 cm SUPPORT FREE HERE THE VIDEO!