Bambu Lab - Poop Bucket, Filament Waste Bin - X1 and X1 Carbon

by mikyleee

Thanks for all of the downloads! If you like this design, check out my AMS Desiccant Trays with Rechargeable Silica Gel: https://cults3d.com/en/creations/bambu-lab-ams-rear-desiccant-refillable-tray UPDATE 3: I have now added a fourth version as per request by someone in the comments. This fourth version is both shorter and narrower. I have also removed all files and reuploaded with better naming as it was getting confusing: V1.0 is the original remix, deeper bucket with logo. V1.1 is the shortened version, allows for use with rear spool holder. V1.2 is the narrower version, allows for closer position to wall etc. V1.3 is shortened and narrower. - UPDATE 2: I have also added 'Narrower' Version. The bottom section width is originally 95.25mm - but the narrower version is now 75mm width. - UPDATE: Added the 'Shortened_Height' Version. This is more suitable for use with the rear spool holder. Top edge is 25mm lower than the original. I remixed this as some are very chunky but I liked the original POOPY SHOE by RAMServices1959 as it's much nicer - but it didn't have a logo on the part and lower section is quite shallow. I also wanted to make the lower section a bit deeper so it could hold more waste as I'm lazy and don't want to have to empty it too often. Poop should fall out of the back, slide down into the lower section and then it's easy to just grab a handful out and put into my filament recycling. I've included my Bambu 3MF file, the STEP file and two STL formats, one is a custom high density STL setting, the other is advanced mesh refinement setting - both should be good but personal preference. Single-part, multi-colour print. Yes, it's a big part - import it > orient it > rotate it away from 'keep-out' zone > right-click > centre it. You may need to move the Purge Tower to a more suitable location, unless using the 3MF. Thanks!