JG BAR-10 Airsoft Suppressor

by pancakesplease

Created in Fusion 360. It took a while to just figure out what the thread was on the JG BAR-10's outer barrel was. It turns out the thread is a left hand ANSI Metric M20x1 thread profile, I found it using Fusion 360. The thread is halfway in the middle of the suppressor. This conceals the end of the barrel (I needed it to because I scratched my barrel removing the orange tip) and it should be a little stronger, less likely to break off. I've printed mine in PLA. No supports needed if you print with the shooty-end down. Easy to sand and spray with primer and paint, it looks manufactured.