Pickleball Net Repair Part

by Bob99

This is a sturdy repair for when the center pole of a pickleball net breaks through the top ‘tape’ of the net.I recommend:Use TPU type filament for strength and durabilityPrint the part laying on its side for maximum strength in the critical axisNo need for supports but one side of the 'channel' exterior could look a little rough0.2mm layer height works fineINSTALLATION: You need two smaller Zip Ties. Poke four holes in the net's top tape to match the holes in the repair part. Insert the Zip Ties as shown in the photo, pull tight and snip off the excess (try not to leave any extra ‘stub’ projecting in the Zip Tie to avoid someone being scratched by a sharp edge.)