Planter and Bowl 22 - Kitty Cat, with drainage hole and saucer (MMU ready)

by MaxT

https://www.buymeacoffee.com/maxt ---------------------- Use it as a planter, or as a food bowl, or anything else. Size it up/down as you wish - make it small, medium, or go large! Use it with or without a saucer - it all depends on your usage. No matter what, I suggest adding some felt pads to the bottom to minimize the probability of scratching your table/floor, and to ensure some ventilation under the planter/saucer to minimize condensation issues.   SETTINGS / PRINTING (recommendation) Filament: PETG or PLA. Please note that PLA can deform/break down in the sunlight. In addition, some types of PLA are biodegradable. Print: 0.2mm Nozzle: 0.4mm Support: Not required Brim: Not required Infill: 1 5-25% (depending on the size of the planter, soil type, plant size, etc) Perimeters: at least 2, best 3 (minimizing probability of holes and water damage to your table) Vase mode: No. While it is tempting to 3D print planters in the Vase mode, I find that there is just not enough fusion between the layers. In addition, a few micro-holes may appear during the sanding/handling of the finished planter. The water will find its way, even through a rock, so there's no reason to risk it. OTHER - If you are really worried that the planter might leak, use a waterproof sealant spray (for example Rust-Oleum Crystal Clear) inside of the planter, 3-4 coatings should be enough. You could also read the official Prusa blog post “ Watertight 3D printing PT1: Vases, cups and other open models ”. - To minimize soil from migrating out of the pot drain hole, use a mesh pad/drainage net - and it will keep your deck, house, or table clean. - To make the planter smooth and shiny, you could use sandpaper, prime it, (spray)paint it a couple of times and use a varnish coat on top.   Happy Printing! -------------- https://www.buymeacoffee.com/maxt