Starlink (Gen 3) antenna bracket for tube post

by 3dideadigital

Support for the installation of the Starlink antenna on tube pole of the following sizes: 38mm, 40mm, 41mm, 42mm, 43mm, 45mm, 50mm (I will be adding sizes as requested). Hardly needs support for printing (only for the upper flange). REMEMBER TO ACTIVATE : "Support critical regions only" (see image). The 3mf files already go with this configuration. Very robust design for maximum strength. The cable can be passed through the center of the tube or outside. Each measurement has a 1mm tolerance that tapers along the tube entrance. This means that for the 45mm size in the design the hole starts at 46mm diameter and tapers to 45mm at the end of the extrusion.