Adderini arms for 5mm Thera-Tube

by flowweber

After I had printed the Adderini completely out of PETG, I wanted to get a little more power out of it. And it came as it had to, the good piece broke. I then reprinted all the load-bearing parts again with carbon reinforced PETG and after that there was much more load-bearing power. the problem now was that the original arms were too small for more material :( All available "tuning arms" I downloaded and tested, all of them tore out or simply broke. So I made this sturdier version of the arms and am very happy with the result. Measured I have not, but the arrows are partly stuck so firmly in the wood that they can not be removed without damage xD the 3mm hole I have expanded to 4mm and reinforced the area behind it, so you have to make a minimal change to the Adderini itself. Nähmlich the hole for the grub screw to 4mm aufbohren and then use a M4 grub screw. P.s. With Carbonfill filament go quite easily 4-5 Nozzles on it, I have changed every 6 hours to guarantee perfect results.